# revolve_3 (plate with hole)
# written by John Dannenhoffer

# generate plate SheetBody with hole
BOX       0  2  0  3  2  0
UDPRIM    ellipse   rx 1/2  ry 1/2
TRANSLATE 3/2  3  0
SUBTRACT

# perform the REVOLVE around negative-x-axis (SolidBody)
REVOLVE   0  0  0  -1  0  0  180
ASSERT    @itype  3

SELECT    FACE   @nbody 1     # iford=1 in red
ATTRIBUTE _color $red
SELECT    FACE   @nbody 2     # iford=2 in green
ATTRIBUTE _color $green
SELECT    FACE   @nbody 3     # iford=3 in blue
ATTRIBUTE _color $blue
SELECT    FACE   @nbody 4     # iford=4 in cyan
ATTRIBUTE _color $cyan
SELECT    FACE   @nbody 5     # iford=5 in magenta
ATTRIBUTE _color $magenta
SELECT    FACE   @nbody 6     # iford=6 in yellow
ATTRIBUTE _color $yellow
SELECT    FACE   @nbody 7     # iford=7 in lightred
ATTRIBUTE _color $lred
SELECT    FACE   @nbody 8     # iford=8 in lightgreen
ATTRIBUTE _color $lgreen

END