# solbeg_1
# written by John Dannenhoffer

# design parameters
DESPMTR   L1   3.5
DESPMTR   L2   2.0

# initial guesses for corner locations
SET       t1   45.0
SET       t2  135.0

# make outline of sketch before solving
SKBEG     0            0            0
   LINSEG 2            0            0
   LINSEG L1*cosd(t1)  L1*sind(t1)  0
   LINSEG 0            0            0
SKEND  1

# start the solver with these dependent variables
SOLBEG    t1;t2;

   # apply the constraints (which are 0 when satisfied)
   SOLCON   (0+L1*cosd(t1))-(2+L2*cosd(t2))
   SOLCON   (0+L1*sind(t1))-(0+L2*sind(t2))
SOLEND

# show converged results
MESSAGE   !$t1=+t1
MESSAGE   !$t2=+t2

# show sketch after solving
SKBEG     0            0            0
   LINSEG 2            0            0
   LINSEG L1*cosd(t1)  L1*sind(t1)  0
   LINSEG 0            0            0
SKEND

END